Several measures adopted by welding aluminum high-frequency power ① higher frequency antenna tube, for 100KW device uses 600 ~ 700KHz Shandong antenna tube manufacturers, 60KW equipment using 700 ~ 800KHz. ② tube anode power supply uses 12-phase rectifier Jinan antenna pipe suppliers, and to install a smoothing filter, the use of SCR voltage regulator, should make it work in a smaller conduction angle state to reduce the pulsating rectified factor. ③ higher output power, so that a higher welding speed tubes. ④ reasonable oscillation circuit, the load should be done to facilitate adjustment. Porthole design is too large (especially for low profile extrusion ratio), so squeezing pressure is reduced, thereby reducing the welding force. Recommend vent hole from the edge of the extruder barrel wall has at least 6-10mm distance. Vent hole course selection and bypass bridge structure considered together better. 2. welding chamber volume is too shallow or too small Jinan antenna pipe prices, can not form a sufficient water pressure. Reasonable is to ensure core rigidity and strength of the premise, to increase the volume of the welding chamber. Welding chamber can be increased cross-sectional area, it may also increase the height of the welding chamber. Antenna tube professional manufacturers, antenna tube, rolls Alcoa (Views) provided by Jinan Heshun Aluminium Limited. Jinan Heshun Aluminum Co., Ltd. (www.jnhsly.com) (www.jnhsly.cn) is specialized in "aluminum, aluminum, aluminum, aluminum rod, aluminum row, aluminum, aluminum rod, aluminum elbow" of the enterprise the company of "honesty, hard service" concept, to provide you with the highest quality products and services. Welcome to inquire! Contact: Zhang.